911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-1070005.png)
1. Cut two strips of tricot tape each approx. 40 mm long.
NOTE:
-
The bonding surfaces must be clean and free of grease.
-
Make sure that the bonding areas overlap sufficiently both inside and out and also that bonding is guaranteed by using contact pressure.
2. Stick and overlap tricot tape -1- at the centre of the outer edge of the rear side section flap -2- (-arrows-).
Subsequent work
1. Install rear side section flap at the left and right.
