911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
Installing hydraulic pump
CAUTION: Damage to hydraulic lines.
-
Do not bend, trap or crush hydraulic lines when removing and installing.
-
Pay special attention when routing hydraulic lines in the clips.
NOTE: Always replace sealing rings.
1. Screw down silent mount -5-.
2. Push on sealing rings -3, 4- and hydraulic lines -A- with the red ring. Screw in banjo bolt -2A- on the lower or right side of the hydraulic pump -1-
. Tightening torque Tightening torque: 9 ftlb.+1.5 ftlb.
3. Push on sealing rings -3, 4- and hydraulic lines -B- with the blue ring. Screw in banjo bolt -2B- on the upper or left side of the hydraulic pump -1- .
Tightening torque Tightening torque: 9 ftlb.+1.5 ftlb.
4. Position hydraulic pump -3- on holder for hydraulic pump -4- -arrow A- and screw down the fastening nuts -2-.