911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
3. Loosen the fastening screw while a second person helps by countering with the special tool holding wrench 9732.
4. Unscrew fastening screw and remove vibration damper -watch the friction washer between the damper and the crankshaft flange.
Removing belt pulley (3.6l) - engine installed
Note: To release and tighten the belt pulley, a second person must counter with the relevant retaining tool.
Component overview
^
1 - Belt pulley
^
2 -Washer
^
3 -Fastening screw
1. Position retaining device 9593 and a large torque wrench on the belt pulley and loosen the fastening screw. second person must counter with the
retaining tool.
2. Unscrew fastening screw and remove belt pulley.
Installing belt pulley/vibration damper - engine installed