911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
4. Unscrew four coated M6 x 35 Torx screws -1- on crankcase half 4-6 on flywheel side. Replace screws during assembly.
5. Unscrew 20 remaining M6 x 35 Torx screws in the crankcase cross bolt connection.
6. Unscrew the star screw that fixes crankcase half 4-6 to the engine support -arrow-.
7. Tap the crankcase halves gently with a plastic hammer. Carefully lever the various cast lugs with a screwdriver to separate the crankcase halves
from one another.
ATTENTION: Crankcase half 4-6 incorrectly levered off
^
Damage to pistons, piston rings
^
Lever off crankcase half 4-6 only with the help of a second person.
8. Carefully lever off crankcase half 4-6 with the help of a second person to avoid damaging the pistons (e.g. by tilting). Remove old shaft seals.
9. For the following steps, fasten the gear carrier to crankcase housing half 1-3 with two cylinder-head screws using spacer sleeves 9613. Tightening