911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
3. Remove ignition coils -1-. Pull off remaining ignition coil cable plugs. Unscrew two M6 25 Torx socket screws, pull the ignition coils out of the
spark-plug recess.
4. Remove support and retainer plates (with integrated seal) for the solenoid hydraulic valves (camshaft timing and valve lift control) -2-,. If the
valves do not have to be replaced, these can remain in the cylinder head (side 1-3 both, side 4-6 camshaft timing only)
5. If the solenoid hydraulic valve is removed for camshaft timing, the oil strainer -1- must be checked for damage and contamination, and replaced if
necessary.
6. Remove oil suction pump. Unscrew four M6 20 Torx screws (micro-self-locking), remove oil suction pump, replace O-ring and screws.
ATTENTION: Damage when levering off the cylinder head cover
^
Cast lugs could break.
^
Perform work steps carefully and gently.