911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-307004.png)
The socket for tightening the fastening screws of the intake distributor should be secured with a strip of insulating tape to prevent them falling out.
If necessary, carry out the work using a small mirror.
4. Screw in and tighten fastening screws of the intake distributor, using a magnet if necessary Tightening torque: 7.5 ft.lb.
5. Check sealing rings of injection valves and replace if necessary. Clean sealing surfaces with a lint-free cloth and apply a thin coat of silicone spray.
Insert fuel distributor pipe together with fitted injection valves into the appropriate openings of the intake distributor and screw in the fastening
screws of the fuel distributor pipe to the intake distributor -1-. Tighten screws Tightening torque: 7.5 ft.lb.
6. Lift engine into position with the car jack and fasten Tightening torque: 63 ft.lb.
7. Move cable duct into position on the fuel distributor pipe and clip in. Connect cable plugs for switch-over valve -1- and camshaft position sensor
-2-.
8. Fit cable plug to switch-over valve -1-. Fit vacuum pipes to the switch-over valve -4-.
9. Separate the tie-wraps and move lines into the installation position.
