911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-319003.png)
7. Insert exhaust camshaft sprocket in the timing chain and position on camshaft flange. The four threaded bores in the camshaft flange must be
covered by the slots of the sprocket in the clockwise running direction of the engine approximately half way -arrows-.
8. Oil the bearing surfaces of the camshafts with new engine oil.
Note: Do not interchange the thrust bearings of the inlet and exhaust camshafts during assembly; observe identification markings.
9. Insert three thrust bearings and one housing -arrows- for the bearing sleeve of the camshafts together with the guide rail for the timing chain.
10. Insert eight housing screws (Torx): six M6 35 -1- and two M6 40 -2- for camshaft bearing and guide rail. Tighten screws evenly and just
finger-tight.
Adjust timing, cylinder bank - 6
