911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
Installing the condenser-condenser line
INFORMATION:
-
When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm openended wrench.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
1. Carefully push the lines into the condensers and screw tight with the fastening screws. - Tightening torque: 14 Nm (10.5 ftlb.)
2. Attach line to both holders, close holders and secure with fastening screws.
3. Engage air guide on condenser -A- and screw down using the two fastening screws -1-. - Tightening torque: 4 Nm (3 ftlb.)
Subsequent work
Subsequent work for line condenser-condenser
Filling in refrigerant.
Install front apron.
Removing and Installing Compressor-Condenser Line At Front
Removing And Installing Compressor-condenser Line At Front
Technical values