911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
2. Press the bulbs into the bulb holders -Arrow A-, turn them anti-clockwise -Arrow B- and take them out of the bulb holders -Arrow C-.
Installing bulb for rear light
INFORMATION: All three bulbs are two-filament bulbs with offset locking pins. Always insert the bulb at the correct position in the bulb holder.
1. Press the bulbs into the bulb holder -Arrow A- and turn them -Arrow B- until the bulbs engage securely in the bulb holders.
2. Insert the bulb holders with the bulbs into the rear light -Arrow A- and lock them -Arrow B-.
Subsequent work
Install rear light.
Removing and Installing Bulb For Luggage Compartment Light
Removing And Installing Bulb For Luggage Compartment Light
Removing bulb for luggage compartment light
Removing luggage compartment light
CAUTION:
Danger of damage to property if bulbs are used or handled incorrectly.
-
Risk of damage to bulbs and bulb housing.
-
Switch off ignition and remove ignition key.
-
To prevent short circuits, the load in question must be switched off while changing bulbs.
-
Only bulbs specified in the bulb table may be used.
-
Bulbs with a higher wattage may damage the bulb housing.
-
New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when
changing bulbs.
-
In certain states, it is compulsory to carry spare light bulbs.