911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-165012.png)
2. Unscrew the fastening screw -3- at the disconnection point ahead of the rubber mounting and remove the line from the engine compartment.
Installing compressor-condenser line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
1. Carefully insert the line into the engine-compartment disconnection point and fasten with the fastening screw -3-. - Tightening torque: 14 Nm
(10.5 ftlb.)
2. Push the line on and fasten it with the fastening screw -2-. - Tightening torque: 21 Nm (16 ftlb.)
Subsequent work
Subsequent work on compressor-condenser line
Screw compressor to engine block.
Install drive belt.
Fill in refrigerant.
Removing and Installing Condenser-Fluid Tank Line
Removing And Installing Condenser-Fluid Tank Line
Technical values
