porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 3638 > < Procedures|Page 3636
Page 42
background image

INFORMATION:  Only in the cabriolet.

11. Remove roll-over bar.
12. Remove auxiliary brake light.
13. Remove rear light at left and right.
14. Remove rear spoiler.
15. Remove air cleaner housing.
16. Remove reservoir.
17. Remove rear underbody cover.

INFORMATION:  Only for vehicles with tyre pressure monitoring

18. Remove rear wheel housing liner.

Removing rear wire harness

Exposing rear wire harness

1. Remove left footwell trim panel.

1.1. Remove fuse carrier cover -1- ( -arrow A- ).
1.2. Unscrew the three fastening screws -2- and take off the footwell trim panel -3- ( -arrow B- ).

2. Remove right footwell trim panel.

2.1. Partly loosen floor covering -1- at the bottom in the area of the A-pillar -arrow A-.
2.2. Unscrew both plastic nuts -2- and take off the footwell trim panel -3- ( -arrow B- ).

3. Loosen seat belt mount at left and right.

3.1. Press off cap -1- with a screwdriver and unscrew the fastening screw -2-. Remove seat belt with fitting -3- and spacer sleeve -4-.

4. Disengage floor covering at the support and lay it in the vehicle interior.

Procedures|Page 3638 > < Procedures|Page 3636