911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
1. Turn airbag connector socket 90 degrees to the left -arrow A- and remove it from the seat shell -arrow B-.
2. Disconnect airbag connector socket.
2.1. Remove tie-wrap -2- on the airbag connector socket -1-.
2.2. Release the connector socket -1- ( -arrows A- ) and remove the two single connectors -3- ( -arrow B- ).
3. Remove the two tie-wraps -1- on the seat shell.
4. Remove wire harness.
4.1. Lift up both pieces of padding -arrows A-
4.2. Unscrew the fastening screw -1- and take off the cover -2- - -arrow B-
4.3. Remove the two tie-wraps -3-.
4.4. Pull the wire harness out of the seat shell and out of the backrest -arrows C-.
Installing wire harness for seat (folding sports bucket seat)
1. Install wire harness.
1.1. Lift up both pieces of padding -arrows A-
1.2. Push the wire harness through the backrest and the seat shell -arrows B- and route it correctly.
1.3. Position the cover -2- ( -arrow C- ) and secure it with the fastening screw -1-. Make sure the line routing is correct.