911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-755067.png)
1. Install ground strap for battery -1-
1.1. Screw down battery ground strap on the body with the fastening nut. - Tightening torque: 5 Nm (3.5 ftlb.)
2. Install B+ line for battery -2-.
2.1. Push the B+ line of the battery onto the mounting point at the power distributor as far as the stop. Check that the B+ line sits firmly.
2.2. Screw B+ line tightly to battery. - Tightening torque: 5 Nm (3.5 ftlb.)
INFORMATION:
-
The electric lines are located in the plenum panel and are thus exposed to the highest demands.
-
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
-
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The
procedures are described in detail in the repair kit for harnesses NR.155-1.
-
Crimping samples are to be prepared before beginning work.
3. Crimp the positive cable.
3.1. Trim the new positive cable -4- to the -dimension X = approx. 20 cm- and strip the insulation.
