911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-755068.png)
3.2. Strip insulation off original positive cable of main wire harness -3- and push on the shrink-fit hose -5-.
3.3. Crimp crimping sleeve -6- using the hand crimping pliers from the repair kit for harnesses NR.155-1 to the positive cable -3-.
3.4. Crimp crimping sleeve -6- using the hand crimping pliers from the repair kit for harnesses NR.155-1 to the new positive cable -4-. Check the
crimp connection carefully.
3.5. Slide the shrink-fit hose over the crimp connection and carefully shrink it using the hot-air blower with special nozzle (recommended
accessories for the repair kit for harnesses) so that it is watertight.
3.6. Tie positive cable to the main wire harness with adhesive tape.
Install B+ line from power distributor to transmission connection point
1. Install B+ line -3-.
1.1. Lay B+ line to transmission and push into the vehicle interior -Arrow A-.
1.2. Press B+ line into the grommet -Arrow B-.
1.3. Fit grommet -Arrow C-.
INFORMATION: For vehicles with manual transmission.
