911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
15. Screw down ground straps -21- and connect plug connection on speed sender -23-.
15.1. Position ground straps -21- and screw down the fastening screw. - Tightening torque: 10 Nm (7.5 ftlb.)
15.2. Push the plug connection -23- together until it is felt to engage.
15.3. Push plug connection -23- into holder.
16. Screw down ground straps -22-.
16.1. Position ground straps -22- and screw down the fastening screw. - Tightening torque: 10 Nm (7.5 ftlb.)
17. Connect plugs on the two solenoid hydraulic valves (valve lift control) -19 and 20- until they click into place.
18. Connect plugs on the two solenoid hydraulic valves (camshaft timing) -17 and 18- until they click into place.
19. Plug in connectors on the two knock sensors -15 and 16- until they click into place.
20. Connect plugs on the six fuel injectors -7 to 12- until they engage securely.
21. Connect plugs on the six ignition coils -1 to 6- until they engage securely.
Subsequent work
1. Install intake-air distributor.
2. Install the generator.
3. Carry out work instructions after disconnecting the battery.
4. Mount rear wheels.
Removing and Installing Wire Harness For Front-End
Removing And Installing Wire Harness For Front-end
Technical values
Preliminary work
1. Disconnect battery.
2. Remove luggage compartment linings
3. Remove front-end control unit.
4. Remove left and right headlight.
5. Remove front apron.
Removing wire harness for front-end