911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
1. Unscrew fastening screw -3-.
2. Push a screwdriver into the openings -A- and unclip the four clips holding the cover -1-.
3. Release and unplug both electric connectors -A- and disengage the left and right electric lines on the control unit.
4. Unscrew the fastening nuts -2-, lift up the control unit and detach it.
Installing front control unit
WARNING:
Risk of damage to electronic control modules.
-
If care is not taken, electrical and electronic components may be destroyed.
-
Before removing the control module, switch off the ignition and remove the ignition key.
1. Insert the front control unit into the body and secure with the fastening nut -2-.Tightening torque: 7.0 ftlb.