911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
Seat Belt: Service and Repair
Removing and Installing Front Three-Point Belt
691119 Removing And Installing Front Three-point Belt
Preliminary work
1. Disconnect battery. Refer to Work instructions after disconnecting the battery
2. Remove rear side trim panel. Refer to Removing and installing rear side trim panel
General warning notes
Safety instructions for seat-belt pretensioner unit
DANGER: Removing and installing seat-belt tensioner unit.
-
Danger of injury and damage to property as a result of incorrect handling of seat-belt tensioner units.
-
Always observe the safety regulations for handling seat-belt tensioner units. Refer to Safety regulations for airbag and seat-belt tensioner units
-
Disposal regulations for seat-belt tensioner units must be observed. Refer to Disposal of airbag and seat-belt tensioner units
-
If removed for an extended period, the seat-belt tensioner unit must be kept in a secure location.
-
Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is avoided.
Refer to Work instructions after disconnecting the battery
-
After the battery is disconnected, always wait for 1 minute before disconnecting the seat-belt tensioner plugs.
Removing front three-point belt