911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-727003.png)
1. Release connector on triggering unit for airbag -10- and fold open the locking lever.
2. Remove connector from the relevant component.
2.1. Connectors for stage 1 and stage 2 of passenger's airbag unit -1 and 2-
Release and remove connectors for stage 1 and stage 2 of passenger's airbag unit
2.2. Connector for seat-belt pretensioner, left -7- and right -8-
Release and remove connector on seat-belt pretensioner.
Remove rubber sleeves -9-.
2.3. Cut off the connector of the damaged wire harness, isolate it and secure it to the main wire harness with tie-wraps.
3. Using a small screwdriver, lever the seal out of the connector housing.
4. Cut and remove tie-wrap for fixing the wire harness to the connector housing.
5. Release connector housing with a small screwdriver, lift upwards and remove from connector.
6. Lift connector guide and remove from connector.
INFORMATION: Allocation of lines - see wiring diagram.
