911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-727010.png)
25.2. Push connector housing onto the connector until it is felt to engage.
26. Fasten wire harness with a new tie-wrap -arrow- to the connector housing.
27. Insert seal into the connector.
27.1. Before inserting the seal, check for signs of damage, and replace if necessary.
27.2. Insert seal into the connector and press down as far as it will go. Check seal is seated properly.
28. Push on connector of triggering unit for airbag -10- until it is felt to engage, and lock it.
Installing wire harness for airbag from the A-pillar connection point to the head airbag
WARNING:
Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units
-
Remove ignition key. Disconnect battery. Route or isolate the ground strap so that all contact with a ground carrier (e.g. body, seat
frame) is avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
