911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-727119.png)
1. Unlock PASM plug connection -Arrow a- and disconnect it.
INFORMATION: When cutting the PASM wire harness, make sure there is enough length of cable left to join to the new lines.
2. Cut wire harness for PASM at -b- and remove it.
3. Cut through the fabric tape at -c- and expose the remaining PASM wires.
Removing wire harness for rear PASM
1. Unlock PASM plug connection -Arrow a- and disconnect it.
INFORMATION: When cutting the PASM wire harness, make sure there is enough length of cable left to join to the new lines.
2. Cut wire harness for PASM at -b- and remove it.
3. Cut through the fabric tape at -c- and expose the remaining PASM wires.
Installing wire harness for PASM
Installing wire harness for front PASM
1. Press the PASM plug connection together until it clicks into place.
INFORMATION:
