911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
7. Bend up the tabs -A- at the body opening and push the rubber sleeve outward through the body opening.
Installing selector lower cable
Fastening selector lever cable on transmission
Note: The selector lever cable must be layed above the intermediate carrier.
1. Push cable through the body opening from below.
2. Apply a coating of lubricant (e.g. Contifix tyre mounting paste) on the rubber sleeve and B+ wiring in the area of the body opening, insert the B+
wiring in the rubber sleeve and press rubber sleeve into the body opening.
Note: During installation, make sure the selector lever on the transmission is in position P (stop to the rear).
3. Clip selector lever cable into support on transmission and press end piece of selector lever onto transmission.
4. Fit plastic cover -A- around pinion shaft.