911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
Drive/Propeller Shaft: Service and Repair
Removing and installing cardan shaft
Tools
Preliminary work
1. Raise the vehicle at the specified jacking points.
2. Remove underbody panel.
Removing cardan shaft
Note:
^
Observe max. joint angle of 20° when removing and fitting. Furthermore, the cardan joint must not be loaded at max. deflection (stop).
1. Support transmission in installation position with the transmission jack and remove transmission bracket.
2. Secure transmission to gear support with the two fastening screws.