911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
Greasing lid
7.1.
Coat sealing surface of lid -arrow- and bellows holder with special sealant.
7.2.
Push on lid and bellows holder evenly from inner CV joint at congruent holes (holes for the fastening screws) with a plastic hammer (do not
use force).
Marking drive shaft
8. Position and secure bellows.
8.1.
In monobloc drive shafts in accordance with the marking that was made previously -arrows-. In friction-welded drive shafts, between the
relevant depressions.
8.2.
Tighten clips or clamps.
Tighten the clamps using the special pliers vag 1275 or a commercially available special pliers.