911 Carrera 4 Cabriolet AWD F6-3600cc 3.6L SOHC (1990)
4.
Cut out template, align in cross member, center punch and drill two 5 mm holes.
5.
Deburr and coat holes with anticorrosion paint.
6.
Align the lock protection bracket (Part Number 964 501 953 00) with the lower surface of the cross member. If necessary, reshape bracket using a
pair of pliers.
7.
Install the lock protection to the lower surface of the cross member with one 4.8 mm rivet. Line up second hole. Use rivet as a guide, do not fasten.
8.
Drill the two lower holes for the lock protection bracket from the luggage compartment area.
9.
Remove the top guide rivet, move the lock Protection bracket to the side. Deburr the holes and apply rust protection paint.
10.
Line up lock protection bracket and install one upper and two lower 4.8 mm rivets.
11.
Clean drill shavings from luggage compartment.
12.
Paint all visible areas of the lock protection bracket with black paint.
13.
Reinstall the top lock cover with 4 new speed nuts (Part Number 999 507 254 02).
14.
If applicable, reinstall cover in front of battery with two plastic nuts (10 mm wrench size).
15.
Reinstall spare wheel and luggage compartment carpet.
16.
Close the front hood. Push down in the area of the two hood rubber stops to avoid denting the hood.
Unlock hood again and check function of lock and safety catch. If OK, close hood.
Required Tools
6 mm socket
1/2" ratchet
1/2" extension
17 mm socket
Screwdriver
Center punch
Hammer
Drill bit, 5.0 mm diameter
