911 Carrera 4 Cabriolet AWD F6-3600cc 3.6L SOHC (1990)
Figure 6
2.
Push down locking spring on air flow meter wiring plug and disconnect plug (arrow in Figure 6).
3.
To gain access to plug, pull wiring harness with plug between air flow meter and idle stabilizer towards
rear of vehicle.
Figure 3
4.
Pull back rubber boot and cut protective wire covering using side cutter or similar tool (arrow in Figure
3).
Figure 4
5.
Heat protective wire covering with hot air blower to maximum 110~ C (230~ F). Pull off and discard
protective wire covering (Figure 4).
Figure 5
6.
Reinstall rubber boot on plug housing. Loop wiring harness along side of plug and tie wrap as shown in
Figure 5.
