911 Carrera 4 Coupe (996) F6-3.6L (2002)
Roll Bar: Service and Repair
Removing and Installing Roll-Over Bar
Removing And Installing Roll-Over Bar
Safety Instructions For Work On The Roll-Over Protection System
-
It is impermissible to perform repairs on the roll-over bar modules.
-
The roll-over bar modules must be replaced in the event of visible damage or pressure marks.
WARNING:
-
Danger of injury during work on the roll-over protection system.
-
The movement range of the roll-over protection system must be kept clear.
-
Work on the roll-over protection system must be performed only with the ignition key withdrawn.
-
Please note: Do not begin assembly work until after a waiting time of 1 minute has elapsed.
-
Tools or other objects must not be placed in the extension area of the roll-over protection system.
-
Danger of injury during work on the roll-over protection system.
-
Remove the roll-over bar modules only after the roll-over bar has been extended (triggered).
-
After assembly work on the roll-over protection system - but at least every 2 years - the function of the roll-over protection system must be
tested by triggering it via the diagnostic interface of the Porsche System Tester.
-
Perform the function test on the roll-over protection system only with the hardtop and covering cap removed and the convertible top open.
Mechanical Emergency Triggering Of The Roll-Over Protection System
If the roll-over bar modules cannot be triggered via the diagnostic interface, mechanical emergency triggering is possible.
WARNING:
Danger of injury during mechanical emergency actuation.
-
The movement range of the roll-over protection system must be kept clear.