911 Carrera 4 Coupe (996) F6-3.6L (2002)
7.3
Align the additional spoiler lip (A) so that the contours (B) fit perfectly against the rear lid.
Note:
Dimension "X" is measured at the reinforcement rib of the ventilation slots.
Dimension "X" is measured from the outer edge of the rear lid to the tear-off edge.
7.4
Press tear-off edge into place.
8.
Disassembling standard rear lid.
8.1
Remove reflector cover, fan with fan housing, upper part of lock and air guide - refer to Technical Manual.
9.
Fitting rear lid.
9.1
Position retainer plates (A) on rear lid and tighten screws (B).
Tightening torque: 10 Nm (7.5 ftlb.).
Note:
Insert screws with securing compound.