911 Carrera 4 Coupe (996) F6-3.6L (2002)
-
Lever off shift and selector cables (1/2) using a commercially available removal tool.
-
Disengage support bracket sleeves (A/B) on the support bracket. To do this, release the support bracket sleeves (press tabs in the direction
indicated by the arrow) and carefully pull them out of the support bracket.
9. Remove cross member.
10. Place transmission jack under the transmission and remove transmission support.
11. From the passenger compartment, press rubber sleeve out to the rear and pull B+ wire out of the slotted sleeve.
Installation
Information
^
Each time the shift cables are removed from the transmission lever, the retaining clips of the shift cable end pieces must be replaced.
1. Position rubber sleeve.
1 - Rubber sleeve
2. Apply a generous coating of lubricant (e.g. Contifix tire mounting paste) on the rubber sleeve and B+ wire in the area of the body opening.
3. Push shift and selector cables through the body opening from behind. Take care not to soil the vehicle interior.