911 Carrera 4 Coupe (996) F6-3.6L (2002)
Control Module: Service and Repair
Tiptronic Control Unit
Removing and installing Tiptronic control unit (as of MY 2002)
Note!
^
The control module is located in the passenger compartment on the right on the B-pillar in front of the rear seat well.
^
The ignition key must be removed before starting the assembly work.
^
If the Tiptronic control module is replaced, observe the points under coding the control module. Go to "Coding Tiptronic control module".
Removing control module
^
Remove front seat.
^
Remove the side lining at rear right.
^
Remove right sill.
1. Unscrew lower fastening screw for the seat belt.
2. Disengage floor covering at the support and lay it in the vehicle interior.
3. Unlock locating peg -1- of the support using the commercially available removal tool.
4. Unscrew fastening screws -2- and nuts -3- and carefully pull the support up and out of the retaining points.