911 Carrera 4S (996) F6-3.6L (2004)
/f6-3.6l/Page-740001.png)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Removing and Installing Hydraulic Unit
Removing and installing hydraulic unit
Removal
Information
^
For the removal and installation of the hydraulic unit -D- the brake master cylinder -B- and the brake booster -C- remain mounted (installed).
1. Switch off ignition. Remove cover -A- from the hydraulic unit/brake unit.
2. Hold down brake pedal with pedal holder, so that the brake fluid does not run out of the expansion tank completely.
3. To remove the hydraulic unit -D-, carry out the following removal procedure:
