911 Carrera 4S (996) F6-3.6L (2004)
/f6-3.6l/Page-294017.png)
1. Manually insert the new circlip into the conical part of the assembly sleeve, special tool 9603/1.
2. Place assembly sleeve 9603/1 onto the assembly tube of special tool 9602. Use assembly aid, special tool 9500/3, to slide the circlip from the
conical sleeve into the assembly tube.
3. Remove assembly sleeve 9603/1 and visually inspect the correct position of the circlip in the assembly tube.
Caution:
Danger of injury if circlip springs out!
-
Check position of the circlip only by visual inspection of the assembly tube from the side.
23. Push assembly tube through the centering piece into the crankcase assembly bore with the circlip fitted.
24. Carefully and gently insert the pressure pin until it contacts the piston pin circlip.
