911 Carrera 4S (996) F6-3.6L (2004)
/f6-3.6l/Page-860002.png)
2. Unscrew links for headlight beam adjustment (headlight height adjustment) on the control arm -arrow- (counter with an open-ended wrench). Only
on left side!
3. Remove rear underbody cover (because of diagonal arm).
4. Remove diagonal arm -1-.
5. Mark position of camber eccentric screw -2- (using a colored pen for example). Remove camber eccentric screw -2- and swivel axle strut
downward.
6. Undo fastening nut from ball joint on wheel carrier -3- (counter with Torx screwdriver 9546 if necessary). Press off axle joint -3- using press-out
tool 9560.
Installation
Caution
Danger of injury and material damage if the wheel carrier is raised incorrectly.
^
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
^
When raising, use a suitable intermediate layer (hard rubber).
^
Do not damage the brake cover plate.
Information
