911 Carrera 4S (997) F6-3.8L (2007)
/f6-3.8l/Page-543003.png)
Release and remove connector on seat-belt pretensioner.
Remove rubber sleeves -9-
2.3. Cut off the connector of the damaged wire harness, isolate it and secure it to the main wire harness with tie-wraps.
3. Using a small screwdriver, lever the seal out of the connector housing.
4. Cut and remove tie-wrap for fixing the wire harness to the connector housing.
5. Release connector housing with a small screwdriver, lift upwards and remove from connector.
6. Lift connector guide and remove from connector.
INFORMATION: Allocation of lines.
7. Release contact of the damaged line using the press-out tool 1575 1P of the press-out and unlocking tools for flat and round plug connections of all
sizes NR.155 ( -arrow a- ) and pull out of the contact strip.
