911 Carrera 4S (997) F6-3.8L (2007)
1. Release electric connectors for the equipment versions (e.g. cigarette lighter, interior sensor etc. -A- and unplug.
2. Disengage retaining clips with wiring harness on centre console and remove the harness.
Installing wiring harness for centre console
INFORMATION:
-
The wire harness for centre console spare parts scope means the scope for fully-equipped vehicles. Depending on the vehicle equipment,
connectors not required are tied to the wire harness for centre console using tie-wraps.
-
When doing this, ensure the lines are routed correctly so that no line becomes trapped or damaged.
1. Lay wiring harness with retaining clips in centre console and push on retaining clips at the points provided.
2. Push electric connectors onto equipment versions until they are felt to engage.
Subsequent work
Subsequent work for interior monitoring sensor
Install centre console.
Removing and Installing Wiring Harness For Rear Spoiler
Removing And Installing Wiring Harness For Rear Spoiler
INFORMATION:
-
Note on removing and installing wiring harness for rear spoiler
-
The wire harness for rear spoiler is not available as spare part.
If the wire harness for the rear spoiler must be replaced, this is only possible together with the spoiler drive.
Replacing Wire Harness For Anti-Lock Brake System (ABS)
Replacing Wire Harness For Anti-lock Brake System (ABS)
Tools