911 Carrera 4S Coupe AWD F6-3600cc 3.6L SOHC (1997)
Braking Sensor/Switch: Adjustments
Checking Stop Light Switch Adjustment
The stop light must light up after a pedal travel of 6-16 mm (measured to the center of the pedal plate).
If the stop light comes on at a pedal travel of less than 6 mm, turn the stop light switch (2) to the right until it is actuated within the tolerance range.
(Take care not to damage the electrical wiring and connector) If the adjustment range of the brake light switch is not sufficient, adjust the brake
pedal at the pivot of brake pushrod 3 (by shortening the pushrod).
If the stop light switch lights up after a pedal travel of more than 16 mm, adjust the brake pedal at the pivot of the brake pushrod (by increasing the
pushrod length) until the stop light switch is actuated within the tolerance range.
