911 Carrera Cabriolet (996) F6-3.4L (1999)
NOTE: In the case of a defective microswitch, the complete wiring harness -4- must be replaced!
1. Refer to "Removing glove compartment".
2. On the retaining bracket -2-, press the locking tabs -A- apart. Guide out the microswitch -5-.
3. Insert a plastic spatula into the side of the interior light -1- and press out. Disconnect the electrical plug connection.
2
-
Installing microswitch and interior light
1. Plug in the electrical plug connection of the interior light -1-. Press the interior light -1- into the cut-out of the glove compartment.
2. Press the microswitch -5- into the retaining bracket -2-. Note the coding of the microswitch.
3. To fit the glove compartment, engage the electrical lead -4- into the clip -3-.
4. Refer to "Installing glove compartment".
Replacing pneumatic shock absorber
1
-
Removing the pneumatic shock absorber
-
Press the pneumatic shock absorber -1- out of the fastening tab -arrow B-. Turn the pneumatic shock absorber by 90 degrees
anti-clockwise in the direction of arrow -A- and guide it out of the glove compartment.
2
-
Installing the pneumatic shock absorber
-
Insert the pneumatic shock absorber -1- and turn it 90 degrees clockwise in the direction of arrow -A-. Insert the pneumatic shock absorber
into the fastening tab towards the -direction of arrow B-.