911 Carrera Cabriolet (996) F6-3.6L (2003)
/f6-3.6l/Page-1312006.png)
CAUTION: Damage to the convertible-top frame it not running synchronously.
-
Bleed the hydraulic system only after the hydraulic cylinders have been removed from the convertible-top sup- ports and drive levers on
the left and right.
The system has a self-bleeding feature. Three to four operations will bleed the system. After bleeding, check the oil level in the container on the
hydraulic pump and check if necessary.
To bleed, the hydraulic valve must be closed. Refer to "Access for opening and closing the hydraulic valve up to model year 2000" and "Access for
opening and closing the hydraulic valve as of model year 2001".
Line routing for replacing the right hydraulic cylinder as of model year 2002
Warning:
-
Damage to hydraulic lines. Do not bend, trap or crush hydraulic lines during installation.
-
The spare hydraulic cylinder has hydraulic lines approx. twice the length of the standard component and can be installed on both sides.
To prevent damage to the hydraulic lines caused by bending, trapping or crushing during installation, line routing has to be consequently
carried out.
1. Wrap the hydraulic lines around the support of the frame for the roll-over bar 1x. Fix the lines with a tie wrap -arrow-.
2. The lines should be free of tension and twisting when connecting to the pump. Observe allocation of the hydraulic lines! -Blue, red-, refer to
"Removing and installing hydraulic cylinders".
Tightening torques
