911 Carrera Cabriolet (996) F6-3.6L (2003)
Figure shows engine side 1 - 3
Tightening torque: 23 Nm (17 ftlb.)
Information
-
Fastening nuts, hexagon-head bolts and seals for the exhaust manifold must be replaced.
13. Fit the exhaust manifold. To do this, put three new M8 fastening nuts and a new metal seal on the catalytic converter flange. Then fasten the
exhaust manifold on the cylinder head with six new M8 x 28 hexagon-head bolts and a new seal.
14. Tighten 9 M8 screw connections with the prescribed torque.
Tightening torque: 23 Nm (17 ftlb.)
15. Raise the engine again and then tighten the two collar nuts (a/f 18) on the engine mounts. Check hoses and cables for damage.
Tightening torque 85 Nm (63 ftlb.)
16. Fit shield: Tighten 2 M6x16 hexagon-head bolts.
Tightening torque 10 Nm (7.5 ftlb.
17. Fit ground cable on cylinder head. Tighten 1 M8 hexagon-head bolt.
Tightening torque: 23 Nm (17 ftlb.)
18. Push the 2 cable plugs onto the oil pressure sensor.
19. Refit rear muffler.
20. Fill in engine oil and check the engine oil level (top up if necessary).
21. Connect the battery.