911 Carrera Cabriolet (996) F6-3.6L (2003)
3. Plug in the electrical plug connection.
4. Position the support and engage in lower side member.
5. Push in the locating peg -1- of the support and check that it is sitting correctly.
6. Tighten the fastening nuts -3- and the fastening screws -2- . Tightening torque -2- 7.2 Nm (5.5ftlbs.).
7. Lay the floor covering over the support and engage.
Using the Porsche System Tester, read out any faults present in the POSIP menu and erase.
-
Insert sill.
-
Mount the side lining at rear.
-
Installing front seat.
Coding Tiptronic control module
Information