911 Carrera Cabriolet (996) F6-3.6L (2003)
Seat Heater Control Module: Service and Repair
Pin Housing For Seat Heating and Belt Buckle
-
-C- Seat heating pin housing
-
-D- Belt buckle pin housing
1
-
Removing pin housing for seat heating and belt buckle
-
See: Body and Frame/Seats/Service and Repair
1. Cut tie wrap on rear side of central plug with side cutters.
2. Push fuse -2- away from flat connector in -direction of arrow 2-.
3. Pin housing: Push out the belt buckle -D- and seat heating -C- in -direction of arrow 1-.
2
-
Installing pin housing for seat heating and belt buckle
1. First insert the seat heating pin housing -C-, then the belt buckle -D- into the flat connector.
2. Push fuse -2- onto the flat connector.
3. Observe the line route and secure with tie wraps on the rear side of the flat connector.