911 Carrera Cabriolet (997) F6-3.6L (2007)
Keyless Entry Transmitter: Service and Repair
Reworking Remote Control
Reworking remote control
Disassembling remote control
INFORMATION:
To prevent irreparable damage to the PCB as a result of an electrostatic discharge, always observe the following points:
-
Only rework the remote control on a workbench or toolbox.
-
Before opening the remote control, place both hands on the workbench or on the toolbox to ground yourself (place both hands briefly on the
workbench).
-
Then start working immediately.
-
The PCB should only be held carefully at the edge.
-
Insert the PCB into the silicone pad again immediately after removing and assemble the remote control.
1. Insert a small screwdriver between the cover and the lower part of the remote control -arrow- and carefully lift the lid off.
2. Remove silicone pad -1- with PCB from the remote control housing.
3. Remove the PCB -2- from the silicone pad -1-.