911 Carrera Cabriolet (997) F6-3.6L (2007)
-
Polyester products, sanded
-
Cleaned sheet steel, sanded
-
Factory primer and KTL, sanded
-
Aluminum and galvanized base surfaces must be pre-primed with Standox(R) Etching Adhesion Primer
-
Please note base surface pre-treatment instructions:
-> S 5.1
-> S 6.1
-> S 9.2.2
NOTE:
-
Raw material base: Acrylic polyurethane, corrosion inhibition pigments
-
Flash point: 24° C/75.2° F
-
Spec. weight: 1.55 g/cm3
-
Solid content: 70.3% weight/47.7% vol.
-
Theoretical yield as wet-on-wet filler: 13.9 m2/ltr. with a dry coat thickness of 30 microns
-
Theoretical yield: 5.2 m2/ltr. with a dry coat thickness of 80 microns
-
Clean equipment after use with cleaning thinner
VOC value:
-
460 g/l
NOTE:
-
VOC-compliant when used as a sanding filler with up to 8% thinner added.
-
Use with Standox(R) 2K Plasticizer (new) on primed plastics.
WARNING: 2K paints react with moisture. All work equipment, mixing vessels, etc. must therefore be completely water-free.
S 9.5.2.1 Application as a wet-on-wet filler