911 Carrera Cabriolet (997) F6-3.6L (2007)
Checking seat following removal
1. Connect the removed seat to the vehicle's wiring harness via test cable 9745 and test cable 9745/1.
2. Connect electric plug to control module trim panel. Refer to Removing and installing control module trim panel
3. Connect the battery. Refer to IN -Work instructions after disconnecting the battery
4. Switch on ignition.
5. Carry out a function check on the seat components.
6. Switch off ignition after function test and disconnect battery.
7. Disconnect test cable 9745 and test cable 9745/1.
Subsequent work
1. Install cover for front seat. Refer to Removing and installing cover for front seat
Replacing Padding For Front Seat (Folding Sports Bucket Seat)
Replacing Padding For Front Seat (Folding Sports Bucket Seat)
Preliminary work
1. Remove cover for front seat. Refer to Removing and installing seat cover (folding sports bucket seat)
Removing padding for front seat
1. Release Velcro fasteners -1- on the back of the padding -2- all the way around (-Figure A-).