911 Carrera Cabriolet (997) F6-3.6L (2007)
NOTE:
-
The rubber seal for the door must be fitted by hand.
-
Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
-
Check the air vents; they must not be closed or covered.
1. Push rubber seal for door -1- all around the sheetmetal flange.
2. Push rubber seal for door -1- under the cover strip -3- -Arrow A- and screw down with the fastening screw -2-.
Tightening torque -> Tightening torque : 6 Nm (4.5 ftlb.)
Installing cover of three-point seat belt