911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-541005.png)
-> Fit new expanding spring, new retaining pin and securing clip on the brake calliper.
^
Make sure the retaining pin is inserted at the correct position. The side levelling surfaces prevent the retaining pin from twisting in the brake
calliper.
^
Do not grease the back of the disc brake pad.
^
Check disc brakes for wear.
^
The core of the warning contact wire must not be left exposed. Worn insulation is not important.
^
Use a new repair kit.
1. Before installing the brake pads, check the amount of wear on the brake discs.
2. If necessary, push the brake pistons back into their original position using the brake piston resetting fixture 9472 (for 6-piston brake calliper).
3. Fit new disc brake pads.
3.1.
If you are using Pagid P40-2 brake pads, insert new damping plates into the pistons.
The protective film on the damping plates must be removed before installation. When fitting the damping plates on the small pistons, position the
cut-out on the damping plate at the brake-pad guide pins to prevent the damping plate from becoming deformed.
3.2.
Do not fit brake-piston damping plates if you are using the modified brake pads (Pagid P40-3)!
