911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-541006.png)
4. Install expanding spring. Center the retaining pin in the bore using the M8 auxiliary screw. To do this, push the retaining pin back with the
auxiliary screw and then push the retaining pin through. Remove auxiliary screw and tighten new fastening screw at the retaining pin to 30 Nm (22
ftlb.).
5. Fit warning contact wire on the disc brake pads, expanding spring and brake calliper -arrows-.
6. Position disc brake pads by operating the brake several times.
7. Check the brake fluid level and correct it if necessary. The brake fluid level must be between the MIN/MAX marking.
Bedding in the brake pads
New brake pads require a slightly longer bedding-in period for PCCB brake discs than cast iron brake discs. In general, the following applies: New
brake pads must be worn in (bedding-in period), their optimum braking effect is not reached until after a few hundred kilometers. The slightly reduced
braking effect must be compensated for by increased pressure on the brake pedal. The same also applies after changing brake discs.
Subsequent work
Fit wheel.
