911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-291003.png)
3. Separate new combination seal at the dot-dash line.
4. Position coolant pump with new seal on crankcase using two screws, note position of dowel sleeves.
5. Position remaining screws. The longer screws (M6 x 30) -2- are installed at the dowel sleeve position.
6. Tighten all screws equally in diagonally opposite sequence. -> Tightening torque: 10 Nm (7.5 ftlb.)
7. Position drive belt on pulley.
Subsequent work
Subsequent work
Warning: Coolant is hazardous to health.
^
Risk of skin irritation.
-> Wear protective gloves and goggles.
-> In the event of contact with the skin or eyes, wash immediately with plenty of water.
Note: To facilitate assembly of coolant pipes and hoses, smear with Kluber Syntheso Glep or alternatively Kluberplus S06-100 assembly gel
