911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-249008.png)
4. Pull the engine compartment temperature sensor out of the intake distributor 4-6 together with the rubber sleeve -1- and unscrew the rear fastening
screws -2- of the air-conditioning compressor.
5. Unscrew the front fastening screw -arrow- of the air-conditioning compressor. Due to the restricted accessibility, the use of a 3/8 inches extension,
16 degrees movable NR.15 with a long Torx E10 socket wrench is recommended. To lift out the air-conditioning compressor, the screw must be
pulled upwards and held in position.
6. Lift out the air-conditioning compressor with the leads connected and lay to one side on a protective support. Secure additionally with a tie-wrap.
7. Pull the sheetmetal holder between the servo oil lines out of the rubber mounts and remove -arrow-.
8. Remove plastic line between oil mist separator and oil flange and lay to one side.