911 Carrera Cabriolet (997) F6-3.6L (2007)
Timing Plate: Service and Repair
WM 155519 Removing and installing solenoid hydraulic valve (valve lift control)
Removing hydraulic valve for valve lift control
Removing hydraulic valve for valve lift control
Caution: Risk of oil contamination and blocked oil bores
^
Faulty engine parts, engine damage
-> Absolute cleanliness is essential when working on hydraulic valves
Note:
^
Handle the hydraulic valve with care; do not turn it at the valve tip or at the safety contact.
^
A seal against leaks cannot be ensured if there is damage in the area of the retainer plate, therefore handle the pliers indicated with care.
Hydraulic valve for valve lift control
1. Remove the side shield on the relevant side of the engine. To do this, unscrew the two M6 x 16 Torx screws -arrows-.
2. Disconnect cable plug on hydraulic valve -1- by pressing the clip and pulling off the cable plug.