911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-262004.png)
Note:
^
Replace O-ring on hydraulic valve and retainer plate with seal.
^
Observe installation position of the hydraulic valve.
2. Replace the O-ring of the hydraulic valve and coat the new O-ring with engine oil. Insert hydraulic valve into the cylinder head. Pay attention to
installation position while doing this. The groove on the valve -arrow- points to the dowel pin in the cylinder head.
Position of dowel pin in cylinder head
3. Coat seal of the retainer plate with engine oil and slide it over the hydraulic valve.
4. Position two M6 x 20 inner Torx screws complete with support -A- on the valve and tighten the screws. Observe installation position of the cable
terminal (to intake distributor). -> Tightening torque: 7.5 ftlb.
